LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Climate Control System - General Information -- XK/X150) >> Climate Control System - General Information >> Specifications >> Refrigerant Oil Adding Capacities

Refrigerant Oil Adding Capacities

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Vehicles up to 2013 only.
NOTE: Rotate the A/C compressor shaft at least 6 to 8 turns when draining the refrigerant oil.
ITEM MILLILITERS
Condenser core and desiccant bag Add 33
Evaporator Add 46
A/C compressor
  1. Drain old A/C compressor. With drain plug removed and ports uncapped, rotate shaft to remove oil and measure the amount of oil captured. 2. Drain new A/C compressor into a clean vessel. With drain plug removed and ports uncapped, rotate shaft to remove oil. Then add back a quantity of the new oil that is identical to the quantity of oil removed from the old A/C compressor. However, if this quantity is less than 30ml, then make it up to 30ml.
A/C lines - If air conditioning has been operational. Add 10 per line
A/C system after flushing - with new compressor installed No oil should be used-new oil in new compressor is sufficient
A/C system after flushing - without a new compressor installed - remaining A/C compressor oil is to be drained. Compressor and expansion valve must not be flushed (removed from the circuit) Add 110ml oil
A/C compressor drain plug Torque 12Nm


CAUTION: Vehicles from 2013 only.
NOTE: Rotate the A/C compressor shaft at least 6 to 8 turns when draining the refrigerant oil.
ITEM MILLILITERS
A/C condenser core and desiccant bag Add 25ml oil
A/C evaporator Add 30ml oil
A/C compressor
  1. Drain old A/C compressor. With drain plug removed and ports uncapped, rotate shaft to remove A/C compressor oil and measure the amount of oil captured. 2. Drain new A/C compressor into a clean vessel. With drain plug removed and ports uncapped, rotate shaft to remove oil. Then add back a quantity of the new oil that is identical to the quantity of oil removed from the old A/C compressor. However, if this quantity is less than 30ml, then make it up to 30ml.
A/C lines - if air conditioning has been operational. Add 5ml oil per A/C line
A/C system after flushing - with new compressor installed No oil should be used-new oil in new compressor is sufficient
A/C system after flushing - without a new compressor installed - remaining A/C compressor oil is to be drained. Compressor and expansion valve must not be flushed (removed from the circuit) Add 80ml oil
A/C compressor drain plug Torque 12Nm
scientia non olet · About LEMON Manuals