LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Climate Control System - General Information -- XK/X150) >> Climate Control System - General Information >> Diagnosis And Testing >> Pinpoint Tests >> Pinpoint Test F: Electronic Control Valve Tests

Pinpoint Test F: Electronic Control Valve Tests

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. F1: ELECTRONIC CONTROL VALVE TEST 1 
    1. Start the engine
    2. Set the air conditioning to on
    3. Set the temperature to the lowest setting (all zones)
    4. Set the blower speed to maximum
    5. Set the recirculate switch to off
    6. Using the manufacturer approved diagnostic system, check datalogger signal - Compressor/Motor Current (0x99AB)

    Is the datalogger signal value > 0.5A?

    • Yes  : Air conditioning compressor electronic control valve internal failure. Refer to the appropriate system wiring diagram and install a new air conditioning compressor electronic control valve
    • No  : Refer to the appropriate system wiring diagram and check the air conditioning compressor electronic control valve circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair as necessary and retest
scientia non olet · About LEMON Manuals