LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Front Suspension -- XK/X150) >> Front Suspension >> Removal & Installation >> Rear Lower Arm (G537323) >> Installation

Rear Lower Arm (G537323): Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Align to the position noted on removal.

    Install the lower suspension arm.

    • Tighten the nut and bolt to 175 Nm.
  2. Install the forward lower control arm.
    • Install the bolt and tighten the new nut to 60 Nm + 135 degrees.
  3. NOTE: Use an additional wrench to prevent the ball joint rotating.

    Install the lower arm ball joint

    • Clean the component mating faces.
    • Tighten the nut to 92 Nm.
  4. NOTE: Use an additional wrench to prevent the component from rotating.

    Install the stabilizer bar link.

    • Tighten the nuts to 43 Nm.
  5. Connect the height sensor link.
  6. Install the wheel and tire.

    For additional information, refer to: Wheel and Tire (Removal and Installation).

  7. Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment, and adjust if required.
scientia non olet · About LEMON Manuals