LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Front Suspension -- XK/X150) >> Front Suspension >> Removal & Installation >> Front Lower Arm Bushing (G1604744) >> Removal

Front Lower Arm Bushing (G1604744): Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal and installation of the bush requires the use of a press.
  1. G11305557

    Visually inspect the lower arm for signs of a center punch mark. If four marks are located on the lower arm in the area illustrated, install a new front lower arm. 

  2. Only continue with the procedure below if there is less than four marks on the lower front arm.

    Refer to: FRONT LOWER ARM (G537322)  (Removal And Installation).

  3. G11305558

    Measure and note the value both sides of the bush as illustrated prior to removal.

  4. CAUTION: Note the orientation of the bush prior to removal.
    G11283682

    Using suitable marking tools, mark the bush and lower arm prior to removal.

  5. G11305560

    Using the special tools, remove the bush.

    Special Tool(s):  JLR-204-813, JLR-204-814

    General Equipment:  Hydraulic press