LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transmission/Transaxle - V8 N/A 5.0L Petrol / V8 S/C 5.0L Petrol -- XK/X150) >> Automatic Transmission / Transaxle - V8 N/A 5.0L Petrol / V8 S/C 5.0L Petrol >> Transmission Control Module And Main Control Valve Body >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure that when fully fitted, all seals protrude by the same amount.
    • Install the new seals.
    G11291650
    • Install a new seal block.
  2. CAUTION:
    • Install the new seals.
    • Make sure that when fully fitted, all seals protrude by the same amount.
    G11291649
  3. CAUTION: Make sure the manual park release is correctly engaged.
    G11291648

    torque specification: 8 Nm 

  4. CAUTION: Make sure that a new component is installed.
    G11291654
  5. G11291655
  6. G11291645
  7. Refer to: Transmission Fluid Pan, Gasket and Filter  (REMOVAL AND INSTALLATION).
  8. Refer to: Battery Disconnect and Connect (General Procedures).
  9. If a new component has been installed, configure using Jaguar approved diagnostic equipment.
scientia non olet · About LEMON Manuals