LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transmission/Transaxle - V8 N/A 5.0L Petrol / V8 S/C 5.0L Petrol -- XK/X150) >> Automatic Transmission / Transaxle - V8 N/A 5.0L Petrol / V8 S/C 5.0L Petrol >> Input Shaft Seal >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Install a new seal.
    G11291631

    Special Tool(s):  308-246

  2. NOTE: Make sure that the alignment mark is visible through the inspection hole as illustrated.
    G11291632

    Special Tool(s):  307-613

  3. CAUTION: Make sure the torque converter is fully located into the oil pump drive.
    G11291633
  4. Refer to: Battery Disconnect and Connect (General Procedures).
scientia non olet · About LEMON Manuals