LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Engine System - General Information -- XK/X150) >> Engine System - General Information >> Cylinder Head Distortion >> General Procedures >> Check

General Procedures: Check

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. G11284748

    Using a suitable metallic straight edge and feeler gauge, measure the cylinder head face in the areas illustrated. Note the maximum value. 

    2. CAUTION: Machine the minimum  thickness of material from the cylinder head to meet specification. If a selection of cylinder head gaskets are available, increase the thickness of the cylinder head gasket by one size.
NOTE:
  • Prior to having the cylinder head machined, prior approval is required by Jaguar or Land Rover engineering.
  • If the cylinder head requires machining, this must be carried out by a local engineering company.

If the cylinder head exceeds the maximum value (0.2mm), the cylinder head must be machined.

scientia non olet · About LEMON Manuals