LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Rear Drive HALFSHAFTS -- XK/X150) >> Rear Drive HALFSHAFTS >> Rear HALFSHAFT - V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol >> Removal And Installation >> Materials >> Installation

Removal And Installation: Materials: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the components mating faces.
    2. NOTE: Component illustrated, removed for clarity.
  2. G11284312

    Special Tool(s):  100-012, 308-621-1, 308-621-2

    3. CAUTION: Install a new circlip.
  3. G11511132

    Apply a 3 mm (0.125) diameter bead of sealant to the halfshaft splines.

    Material:  Thread Locking HS (WSK-M2G349-A4/6U7J-M2G349-AA)

  4. G11284314

    Install the halfshaft oil seal plutector.

    5. CAUTION:
    • Do not install the rear halfshaft fully at this stage.
    • Only install the rear halfshaft until the halfshaft splines have past the halfshaft oil seal.
  5. G11284315
  6. Remove and discard the halfshaft oil seal plutector.
    7. CAUTION: Make sure that the rear halfshaft circlip is installed correctly by pulling the halfshaft gently to make sure it is engaged.
  7. G11284315
    8. CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.
  8. G11283913

    Torque Specification: 90 Nm 

    9. CAUTION: Install the halfshaft nut finger tight.
    NOTE: The wheel hub nut is not tightened at this stage.
  9. G11283906
    10. CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.
  10. G11283911

    Torque Specification: 150 Nm 

    11. CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.
  11. G11283857

    Torque Specification: 55 Nm 

  12. G11283909

    Torque Specification: 6 Nm 

  13. G11283620
  14. G11283907

    Torque Specification: 103 Nm 

    15. CAUTION: Do not use air tools to install the nut. Failure to follow this instruction may result in damage to the component.
  15. G11283906

    Torque Specification: 300 Nm 

  16. G11284147

    Check and top-up the differential case.

    Torque Specification: 34 Nm 

  17. Refer to: Wheel and Tire
scientia non olet · About LEMON Manuals