Removal And Installation: Removal
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The inboard joint has angularly adjusted roller (AAR) joints. AAR joints have no internal retaining mechanism and can separate.
-
Raise and support the vehicle.
- Remove the halfshaft.
For additional information, refer to: Removal And Installation
Remove and discard the CV joint boot outer retaining clamp.
Remove the outer CV joint.
Remove and discard the circlip.
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
NOTE:
Position and secure component in a bench vice fitted with soft jaws.
CAUTION:
Use a soft face hammer or soft drift to release the C V joint from the retaining circlip.
NOTE:
Note the fitted position.
Remove the outer CV joint boot.
- Remove and discard the CV joint boot inner retaining clamp.