LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Rear Drive HALFSHAFTS -- XK/X150) >> Rear Drive HALFSHAFTS >> Outer Constant Velocity Joint Boot >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the components for deterioration.
    2. NOTE: Align to the position noted on removal.

  2. Install the CV joint boot.

    • Secure the clip.
  3. Install the circlip.
    4. NOTE: Check that the circlip is fully engaged.

  4. Install the outer CV joint.

    5. CAUTION: Only use lubricants meeting the Jaguar specification.

  5. Pack the CV joint with the grease supplied.

    6. CAUTION: Ensure enough air is present in the CV boot before the retaining clip is secured.

  6. Install the CV joint boot to the CV joint.

    • Secure the clip.
  7. Install the halfshaft.

For additional information, refer to: Removal And Installation

scientia non olet · About LEMON Manuals