LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Rear Drive Axle/Differential -- XK/X150) >> Rear Drive Axle/Differential >> Drive Pinion Seal - V8 N/A 4.2L Petrol/V8 S/C 4.2L Petrol >> In-Vehicle Repair >> Special Tool(S) >> Removal

Special Tool(S): Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

  1. Raise and support the vehicle.

  2. Remove the driveshaft.

    For additional information, refer to: Driveshaft

    3. CAUTION:
    • The following step must be carried out to make sure the correct drive pinion flange retaining nut torque is achieved.
    • Only use a paint mark to match mark the drive pinion flange, loosen the nut 180 degrees then tighten back to mark and note the torque value.
  3. G11510936

    Remove the drive pinion flange retaining nut.

    • Mark the drive pinion flange to nut relationship.
    • Loosen the nut 180 degrees, then tighten back to the mark and note the torque value.
  4. G11510937

    Using the special tool, remove the drive pinion flange.

  5. G11510938

Carefully remove and discard the oil seal.

scientia non olet · About LEMON Manuals