LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Parking Aid -- XK/X150) >> Parking Aid >> Parking Aid Module >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the parking aid module.
    • Connect the electrical connectors.
    • Tighten the nuts to 3 Nm (2 lb.ft).
    • Secure the electrical harness.
    • Align the acoustic pad.
  2. Install the subwoofer cover.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    3. CAUTION: Make sure the carpet is correctly installed and that no foul-condition exists when the accelerator pedal is depressed.

  3. Install the carpet.

    • Install the floor console side panel trim.
  4. Install the cowl side trim panel.
    • Carefully align and secure the clips.
    • Secure the scuff plate trim panel.
  5. Connect the battery ground cable and install the cover.

    For additional information, refer to: Battery Disconnect And Connect

scientia non olet · About LEMON Manuals