LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Parking Aid -- XK/X150) >> Parking Aid >> Front Inner Parking Aid Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.

    Vehicles with 4.2L engine 

  2. Remove the front bumper cover.

    For additional information, refer to: Front Bumper Cover

    Vehicles with 5.0L engine 

  3. Remove the front bumper cover.

    For additional information, refer to: Front Bumper Cover

    All vehicles 

  4. See Figure
    G11516009

    Remove the parking aid sensor.

    • Disconnect the electrical connector.
    • Release the 2 clips.