LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Wipers & Washers -- XK/X150) >> Wipers And Washers >> Windshield Washer Reservoir >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rubber mount.
  2. Install the filler neck seal.
  3. Install the windshield washer pump.
    • Install a new seal.
  4. Install the headlamp washer pump.
    • Install a new seal.
    5. NOTE: Do not disassemble further if the component is removed for access only.

  5. Install the washer reservoir low level sensor.

    • Install a new seal.
    6. NOTE: Align to the position noted on removal.

  6. Install the windshield washer reservoir.

    • Connect the washer jet hoses.
    • Connect and secure the electrical connectors.
    • Tighten the bolts to 6 Nm (4 lb.ft).
  7. Install the windshield washer reservoir filler neck.
    • Release the clip.
  8. Install the fender splash shield.

    For additional information, refer to: Fender Splash Shield

  9. Refill the washer reservoir.
scientia non olet · About LEMON Manuals