LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Wipers & Washers -- XK/X150) >> Wipers And Washers >> Rain Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure that the component is secured in the retainer.
    NOTE:
    • Make sure the rain/light sensor windshield area is clear and clean of any contamination inside and out.
    • Prior to switch the ignition ON first time after the rain/light sensor replacement please allow at least 10 minutes for the gel pad to adhere to the windshield surface.
    • If the original rain/light sensor is to be reinstalled, configure and calibrate using Jaguar approved diagnostic equipment.

  1. To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals