LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Wipers & Washers -- XK/X150) >> Wipers And Washers >> Headlamp Washer Jet >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the headlamp washer jet.
    • Tighten the Torx screws.
    • Connect the washer jet hose.
  2. Install the headlamp assembly.
    • Connect and secure the electrical connector.
    • Position the locating pegs.
  3. Connect the washer jet hose.
  4. Secure the headlamp assembly.
    • Tighten the bolts.
  5. Close the hood.
  6. Connect the battery ground cable.

    For additional information, refer to: Battery Disconnect And Connect

scientia non olet · About LEMON Manuals