LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Anti Lock Control - Stability -- XK/X150) >> Anti-Lock Control - Stability Assist >> Hydraulic Control Unit (G532577) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the HCU bracket.
    • Tighten the Torx bolt to 10 Nm (7 lb.ft).
  2. Connect the brake pipe unions.
    • Tighten the brake line unions to 17 Nm (13 lb.ft).
  3. NOTE: When installing the HCU, make sure the locating peg fits securely into the grommet.

    Install the HCU and pipe assembly.

    • Position the locating peg.
    • Tighten the Torx bolts to 10 Nm (7 lb.ft).
    • Tighten the brake line unions to 17 Nm (13 lb.ft).
  4. Connect and secure the electrical connector.
  5. Remove the special tool.
  6. Bleed the brake system.

    For additional information, refer to: Brake System Bleeding (General Procedures).

  7. Install the fender splash shield.

    For additional information, refer to: Fender Splash Shield (Removal and Installation).

  8. Connect the battery ground cable and install the cover.
  9. Using WDS, configure a new HCU.
scientia non olet · About LEMON Manuals