DTC C0063-08: Yaw Rate Sensor - Bus signal / message failures: Action

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

Refer to the electrical wiring diagrams and check the integrity of the power and ground supplies to the yaw sensor. Check the integrity of the bus connections. Repair any harness faults found and retest. If no harness faults are found suspect the yaw sensor, Refer to the Warranty Policy and Procedures manual if a module/component is suspect. To validate the repair, ignition on and wait 10 seconds. Check lamps remain extinguished.