LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Safety Belt System -- XK/X150) >> SEATBELT System >> Rear Safety Belt Retractor - Convertible (G563185) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the safety belt assembly.
    • Install a new Torx bolt and tighten to 45 Nm (33 lb.ft).
    • Position the safety belt through the rear seat backrest trim panel.
  2. Secure the safety belt.
    • Attach the safety belt lower anchor, install a new nut and tighten to 30 Nm (22 lb.ft).
  3. Install the rear safety belt trim panel.
    • Secure with the clips.
    • Tighten the nuts to 10 Nm (7 lb.ft).
  4. Install the rear seat backrest trim panel.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Install the clips.
  5. Install the rear seat backrest.

    For additional information, refer to: Rear Seat Backrest (Removal and Installation).

  6. Close the convertible top.
    • Depress the switch.
scientia non olet · About LEMON Manuals