LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Safety Belt System -- XK/X150) >> SEATBELT System >> Rear Safety Belt Buckle (G539372) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the safety belt stalk.
    • Tighten the Torx bolt to 45 Nm (33 lb.ft).
  2. Install the rear safety belt stalk trim panel.
    • Secure with the clip.
  3. Install the rear seat cushion.

    For additional information, refer to: Rear Seat Cushion (Removal and Installation).

scientia non olet · About LEMON Manuals