Pinpoint Test G: D-Loop Not Rotating Correctly
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
- G1: D-LOOP NOT ROTATING CORRECTLY
- Remove any trim panels required to expose the D loop (anchor point) and the seatbelt retractor. Go to: FRONT SAFETY BELT RETRACTOR (REMOVAL AND INSTALLATION), or REAR SAFETY BELT RETRACTOR - 2-DOOR (G539373) , or REAR SAFETY BELT RETRACTOR - CONVERTIBLE (G563185) .
- Ensure there are no obstructions and the webbing does not catch or rub, the D loop (anchor point) rotates correctly and if installed the confirm the height adjuster operates correctly
- Check for correct operation twice
Does the webbing move freely then retract correctly?
- Yes
Reinstall any trim panels, ensure there are no obstructions and the webbing does not catch or rub. No further action required. Go to: FRONT SAFETY BELT RETRACTOR (REMOVAL AND INSTALLATION), or REAR SAFETY BELT RETRACTOR - 2-DOOR (G539373) , or REAR SAFETY BELT RETRACTOR - CONVERTIBLE (G563185) .
- No
Replace as required. Refer to the warranty policy and procedures manual, or determine if any prior approval program is in operation, prior to the installation of a new module/component
CAUTION:
Do not insert any objects or tools into the buckle head