LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Supplemental Restraint System -- XK/X150) >> Supplemental Restraint System >> Side Impact Sensor - Convertible >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the side impact sensor.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Connect the electrical connector.
  2. Install the rear quarter trim panel.

For additional information, refer to: REAR QUARTER TRIM PANEL - CONVERTIBLE (Removal and Installation).

scientia non olet · About LEMON Manuals