LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Supplemental Restraint System -- XK/X150) >> Supplemental Restraint System >> Side Air Bag Module >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the side air bag module.
    • Attach the backrest cover.
    • Tighten the new nuts to 7 Nm (5 lb.ft).
    • Connect the electrical connector.
  2. Secure the front seat backrest cover central tension straps.
    • Attach to the seat frame.
  3. Secure the front seat backrest cover lower retaining clips.
    • Attach to the seat frame.
  4. Secure the front seat backrest cover rear panel retaining clips.
    • Attach to the seat frame.
    • Attach to the backrest cover.
  5. Secure the front seat backrest cover lower tension straps.
    • Attach to the seat frame.
  6. Install the front seat.

    For additional information, refer to: FRONT ROW SEAT (Removal and Installation).

  7. Connect the battery ground cable and install the cover.

    For additional information, refer to: BATTERY, MOUNTING AND CABLES -- XK/X150 (Specifications).

scientia non olet · About LEMON Manuals