LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Supplemental Restraint System -- XK/X150) >> Supplemental Restraint System >> Rollover Protection Unit >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  2. Install the rear seat backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  3. Install the rear seat backrest trim panel.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Install the clips.
  4. Install the rear seat backrest.

    For additional information, refer to: Rear Seat Backrest (Removal and Installation).

  5. Connect the battery ground cable and install the cover.

    For additional information, refer to: BATTERY, MOUNTING AND CABLES -- XK/X150 (Specifications).

  6. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals