LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Seating -- XK/X150) >> Seating >> Front Row Seat Backrest Cover >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front seat backrest cover.
    • Install the 16 hog rings.
  2. Secure the front seat backrest cover upper tension straps.
    • Pass through the backrest pad.
    • Attach to the seat frame.
  3. Install the side air bag module.
    • Attach the backrest cover.
    • Tighten the new nuts to 7 Nm (5 lb.ft).
    • Connect the electrical connector.
  4. Secure the front seat backrest cover central tension straps.
    • Attach to the seat frame.
  5. Secure the front seat backrest cover lower retaining clips.
    • Attach to the seat frame.
  6. Secure the front seat backrest cover rear panel retaining clips.
    • Attach to the seat frame.
    • Attach to the backrest cover.
  7. Secure the front seat backrest cover lower tension straps.
    • Attach to the seat frame.
  8. Install the front seat backrest tilt handle trim panel.
    • Install and tighten the Torx screws.
    • Install the front seat backrest tilt handle.
    • Install the screw.
  9. Install the front seat head restraint guide tube.
    • Release from the seat frame.
    • Secure in the seat frame.
  10. Install the front seat head restraint.
  11. Install the front seat.

    For additional information, Refer To: FRONT ROW SEAT (G532581)  (Removal and Installation).

scientia non olet · About LEMON Manuals