LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Uni-Body, SUBFRAME & Mounting System -- XK/X150) >> Uni-Body, SUBFRAME And Mounting System >> Rear SUBFRAME Rear Bushing >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Disconnect the battery ground cable.

    For additional information, refer to: Battery Disconnect and Connect

  2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  3. Raise and support the vehicle.

    Vehicles with 4.2L engine 

  4. Remove the rear subframe assembly.

    For additional information, refer to: Rear Subframe

    Vehicles with 5.0L engine 

  5. Remove the rear subframe assembly.

    For additional information, refer to: Rear Subframe - 5.0L 

    All vehicles 

  6. NOTE: Note the fitted position.
  7. See Figure
    G06388803

    Using the special tools, remove and discard the rear subframe rear bushing.