LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Parking Brake & Actuation - Vehicles W/O Carbon Ceramic Brakes -- XK/X150) >> Parking Brake And Actuation >> Parking Brake Cable Tension Release >> General Procedures >> Special Tool(S)

Special Tool(S)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
G11423665
 RELEASE  Electric parking brake release tool 206-082. Only to be used for EMERGENCY brake
G11423666
 RELEASE  Electric parking brake release tool link lead 206-082-01. Only to be used for EMERGENCY brake
WARNING: Failure to release the tension and calibrate the electric parking brake during rear parking brake related service procedures, could cause the parking brake to function incorrectly or become inoperative.
CAUTION:
  • Ensure the vehicle transmission is in park position before the cable tension is released.
  • The warranty of the electric parking brake release tool will be invalidated if the casing has been removed.
NOTE: The tools shown must only be used in the event of an emergency.
    WARNING: Always use Jaguar approved diagnostic equipment to release the cable tension, when carrying out repair operations on the electric park brake which require cable tension release.

  1. Connect the Jaguar approved diagnostic equipment to release the electric parking brake cable tension.

    • Follow the on-screen instructions.
    2. WARNING: The procedure below should only be used in emergency situations, to release the electric park brake. All calibration of the parking brake system will be lost, and the parking brake will need to be re-calibrated to function correctly.
  2. G11511878

    Release the auxiliary junction box access cover.

    • Release from the clip.
  3. G11511879

    Disconnect the parking brake module.

    • Disconnect the 2 electrical connectors in the sequence illustrated.
  4. G11284496

    Connect the special tool.

  5. G06387594

    Release the parking brake cable tension.

    • An audible 'click', signals complete parking brake cable tension release.
  6. G11511882

    Remove the special tool.

    • Reverse the removal sequence, connect and secure the electrical connectors.
  7. Secure the auxiliary junction box access cover.
    • Align the pegs and secure the clip.
    8. WARNING: Calibrate the electric park brake using Jaguar approved diagnostic equipment. If Jaguar approved diagnostic equipment is not available disconnect the battery for approximately 30 seconds, the vehicle will then prompt the driver to carry out the calibration procedure as per the vehicle hand book on re-connection.

Re-calibrate the electric park brake.

scientia non olet · About LEMON Manuals