LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Speed Control -- XK/X150) >> Speed Control - V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol >> Speed Control DEACTIVATOR Switch >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During Installation Of The Brake Switch, Make Sure The Brake Pedal Is Not Depressed At Any Time. Depressing The Pedal May Cause: Poor Operation Of The Brake Light Switch And Brake Lights, Diagnostic Trouble Codes To Be Logged And/Or Failure Of The Vehicle To Start.
  1. Install The Brake Switch.
    • Connect The Electrical Connector.
    • Secure The Clip.
  2. Install The Driver's Side Footwell Trim Panel.
    • Carefully Align And Secure The Clips.
scientia non olet · About LEMON Manuals