LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Parking Brake & Actuation - Vehicles W/Carbon Ceramic Brakes -- XK/X150) >> Parking Brake And Actuation - Vehicles With: Carbon Ceramic Brakes >> Parking Brake Pads - XKRS Gt (G1607965) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
  • Brake pads must be renewed in axle sets only. Failure to follow

    this instruction may result in braking efficiency being impaired.

CAUTION:
  • The parking brake caliper retaining bolts are installed in two left hand thread inserts on the mounting bracket which may loosen and unscrew if the retaining bolts are removed and cause damage to the brake disc, the inserts and the mounting bracket. Therefore it is essential that the following procedure is adhered too.
  • Take care not to contaminate the brake pad friction materials or the brake discs.
  • Take care not to contaminate the brake pad friction materials or the brake discs.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: Parking Brake Cable Tension Release  (General Procedures).
  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. G11297217

    Remove 2 opposing wheel nuts.

    Torque: 125 Nm 

  4. G11297218

    Install the wheel guide tools. (Located in the vehicle tool kit.)

    Torque: 20 Nm 

  5. CAUTION: The brake disc can be easily damaged. Take extra care when removing and installing the wheel.
    G11297219

    Remove the remaining wheel nuts and slide the wheel and tire over the guide tools.

    Torque: 125 Nm 

  6. CAUTION:
    • Discard the bolts.
    • Do not allow the caliper to hang on the brake hose.
    G11511821

    Torque: 110 Nm 

  7. CAUTION: Discard the clip.
    G11511822
  8. NOTE: Note the orientation of the anti-rattle spring prior to removal.
    G11511823

    General Equipment:  Punch

  9. G11511824
  10. CAUTION: Discard the clips.
    G11511825
  11. CAUTION: The brake disc can be easily damaged. Do not strike or lever on the brake disc.
    G11511826
  12. G11511984
  13. G11511985

    Special Tool(s):  206-080, 206-081

  14. Repeat for the other side.
scientia non olet · About LEMON Manuals