Transmission Display
The transmission display is located in the upper section of the LCD.
The transmission position information is sent from the TCM (transmission control module) and the JaguarDrive selector module in high speed CAN messages to the instrument cluster.
The transmission has three modes of operation:
- Conventional automatic operation (JaguarDrive selector in D (drive) position)
- Sport automatic operation (S (sport) selected with JaguarDrive selector)
- Manual gear operation (Jaguar sequential shift).
The following table shows the JaguarDrive selector position and the highlighted indication displayed in the transmission display.
| SELECTOR POSITION | TRANSMISSION DISPLAY |
|---|---|
| P (park) | P |
| R (reverse) | R |
| N (neutral) | N |
| D (drive) | D |
| S (sport) | DS |
The following table shows the Jaguar sequential shift display.
Selections are made using the steering wheel mounted paddle switches.
| JAGUAR SEQUENTIAL SHIFT GEAR SELECTION | TRANSMISSION DISPLAY |
|---|---|
| First | 1 |
| Second | 2 |
| Third | 3 |
| Fourth | 4 |
| Fifth | 5 |
| Sixth | 6 |
The TCM may inhibit a requested up or down shift if the requested gear is outside the normal engine speed operating range. If this occurs, the transmission display will briefly display the gear requested by the driver, but will then change to display the actual gear selection.