LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Information & Message Center -- XK/X150) >> Information And Message Center >> Description And Operation >> Information Display >> Speed Control And Set Speed Displays

Speed Control And Set Speed Displays

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

The following table shows the possible messages which can be displayed, other visual or audible warnings and a description of the message.

MESSAGE OTHER WARNINGS REASON ACTION
OVER LIMIT XXX MPH (km/h)
  • Amber ASL warning indicator illuminated at +4.8 km/h (+3 mph) above limit.
  • Amber ASL warning indicator flashing at +24 km/h (+15 mph) above limit.
  • Amber ASL warning indicator flashing and chime emitted at +24 km/h (+15 mph) for a certain time period.
 Displayed when vehicle speed exceeds the ASL set speed. Reduce vehicle speed to ASL set limit.
LIMITER CANCELLED None. Displayed for 4 seconds when driver deselects ASL. None.
LIMITER SET XXX MPH (km/h) None. Displays new speed setting for the ASL. None.
LIMITER STANDBY None. Displayed when ASL is activated and speed control is selected. None.
LIMITER NOT AVAILABLE None. Displayed when ECM (engine control module) has detected a fault. Use a Jaguar approved diagnostic system to diagnose fault.
TOO FAST TO RESUME None. Displayed when 'Resume' switch is pressed but vehicle speed is 30 km/h (18 mph) above the set speed. Reduce vehicle speed to set speed then press 'Resume' switch.
CRUISE CANCELLED None. Driver has cancelled speed control or the brake pedal has been pressed. Re-activate the speed control system or press the 'Resume' switch on the steering wheel.
CRUISE OVERRIDE None. Driver has pressed the accelerator pedal, overriding the speed control system. Message will go off when accelerator pedal is released and speed control is active.
WARNING: Adaptive cruise braking will be disabled when this message is displayed.
GAP 1/2/3/4 None. Displays the current set or default adaptive speed control distance. Displayed along with a vehicle graphic in the LCD. Chevrons (>) denote gap figure selected If required, adjust distance using the steering wheel switches.
SETSPEED XXX MPH (km/h) None. Displays the new speed input for the speed control. None.
DRIVER INTERVENE None. Immediate action required by the driver to apply the brakes if required.
  • Apply brakes if required.
  • May also be displayed if speed control system loses CAN messages when active.
CRUISE NOT AVAILABLE None. Speed control cannot be engaged. A fault has occurred in the speed control system. Diagnose fault using a Jaguar approved diagnostic system.
RADAR SENSOR BLOCKED None. The adaptive speed control radar sensor has become dirty or obstructed. Remove obstruction or clean the radar sensor.
FORWARD ALERT OFF None. Forward alert has been switched off. No warning will be given for objects in the vehicle's forward direction. None.
FORWARD ALERT None. Forward alert has been switched on or the gap settings have changed. None.
scientia non olet · About LEMON Manuals