DTC B1000-1A: Right Hood Hinge Deployment Control - Circuit resistance below threshold: Action

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: The vehicle must not be driven if the hood has been deployed.

NOTE: Repairs due to a collision are not warrantable.

Check the vehicle for collision damage. Repair as necessary. Install a new right hood latch release deployment control
Refer to the appropriate electrical circuit wiring diagrams and check the right hood latch release deployment control circuit for short circuit between power and ground. Install a new wiring harness as necessary. If no wiring harness fault exists, using the manufacturer approved diagnostic system, clear the DTCs and retest. If the fault persists, install a new right hood latch release deployment control