LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Cooling - V8 5.0L Petrol/V8 S/C 5.0L Petrol -- XK/X150) >> Engine Cooling - V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol >> Coolant Pump - V8 S/C 5.0L Petrol >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).
  2. WARNING: Do not work on or under a vehicle supported only by a jack.

    Always support the vehicle on safety stands.

    Raise and support the vehicle.

  3. Refer to: Engine Cover - V8 5.0L Petrol/V8 S/C 5.0L Petrol (Interior Trim and Ornamentation, Removal and Installation).
  4. Refer to: Cooling System Partial Draining and Vacuum Filling  (General Procedures).
  5. Refer to: Supercharger Belt (Accessory Drive - V8 5.0L Petrol/V8 S/C 5.0L Petrol, Removal and Installation).
  6. G11301406
  7. CAUTION:
    • Make sure that the accessory drive belt is correctly located on each pulley.
    • Clean and inspect the accessory drive belt pulleys for damage.
    G11287255

    Torque Specification: 40 Nm 

  8. G11285355
  9. G11287861
  10. WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.
    CAUTION: Engine coolant will damage the paint finished surfaces. If spilled, immediately remove the coolant and clean the area with water.
    G11287865

    Torque Specification: 12 Nm 

scientia non olet · About LEMON Manuals