Windshield wiper multifunction switch

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

POSITION	RESPONSE
1	Off and Parked
2	Intermittent wipe
3	Slow speed wipe
4	High speed wipe
5	Intermittent wipe rotary collar

Flick wipe - Pull the RH steering column multifunction switch towards the steering wheel to give a single slow speed wipe of the blades. Holding the lever in this position operates the wiper continuously at slow speed until released.

Intermittent wipe (2) - With intermittent wipe selected, turn the rotary collar (5) to vary the delay times between wipes (typical range is 4 seconds to 15 seconds dependant on configuration).

Rain sensor - With the rotary collar (5) in the AUTO position and multifunction switch in the intermittent wipe position (2), the wipers will automatically operate when the rain sensor detects rainfall or moisture on the windshield. With the rain sensor activated, the sensitivity of the rain sensor can be adjusted. Rotate the control upwards to reduce sensitivity of the rain sensor.

NOTE: If rain sensitive wipers are installed and selected, wipers operate automatically until no moisture is detected.