Battery Test

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

The battery may be tested either on a bench or on the vehicle.

The battery condition must be checked in accordance with the battery test process utilizing an appropriate tester as outlined in the equipment section (Section 5) . For additional information, refer to:Battery Care Requirements (Description and Operation).

NOTE: The midtronics code must be recorded on the form.

Any actions must be carried out in accordance with the table shown in the determining battery condition section (Section 6) .

For additional information, refer to: Battery Care Requirements (Description and Operation).

The details must be recorded on the New Vehicle Storage Form which is part of the new vehicle storage document.

For additional information, refer to: New Vehicle Storage Form (Description and Operation).

CAUTION: DO NOT connect the tester to any other circuit or chassis point other than the battery negative terminal.

If the battery is disconnected again after conducting the PDI, certain vehicle electrical systems that are calibrated during the PDI will lose the calibration and will require resetting again once the battery is reconnected. This may include the PDI application and Market configurations.

The battery must be tested to determine that the battery is in good condition, and there is sufficient charge to carry out the PDI. Certain electrical systems require a precise voltage to operate correctly.

Check the battery positive terminal cable and BMS clamp pinch bolts are tightened to 6 Nm.
NOTE: It is imperative, to make sure correct vehicle functionality, that the battery terminal is pushed fully home and is tightened to the specified torque specification.
Connect the Jaguar recommended battery tester to the battery.
Check and record on the PDI check sheet, the battery condition as indicated by the Jaguar recommended battery tester.
CAUTION: It is essential that the battery voltage check is performed. This makes sure the Stop/Start function performs correctly, the battery MUST be in good condition before delivery to the customer.

NOTE: The voltage check must be carried out before connecting the diagnostic equipment. Failure to do this may result in vehicle configuration failure.