Door window controls

One-touch up/anti-trap function reset  - following a battery disconnection/re-connection, the one-touch up/anti-trap action will not operate (all other window control functions are unaffected).

To reset the one-touch up/anti-trap function:

1. Fully close a window then release the switch.
2. For the same window, again pull and hold the switch in the close position for a further 2 seconds.
3. At the same window, fully open the window and release the switch.

   Again press the switch to open the window and hold the switch for a further 2 seconds.

4. Confirm the operation by opening the window and then closing with the one-touch function.
5. Repeat the process for the other electrically operated window.

Anti-trap protection override  in the event when closing the window, the window stops and reverses, this may be due to a blockage such as ice, damage in the glass guide or a misaligned seal, causing the anti-trap function to operate. If there are signs of damage or other faults, the problem must be rectified before proceeding with the PDI checks.

If the stoppage is due to icing, the protection function may be overridden as follows:

1. After the initial attempt to close the window, operate the close switch a second time.
2. When the window has reversed from the blockage, operate the switch (within 10 seconds) until the window stops again (the window will not reverse on the third attempt).
3. Immediately operate the close switch again. The window will now move up a short distance with increased force to override the blockage.
4. Repeat the override action until the window has closed. Each time the window stops, the switch must be operated immediately (within 0.5 seconds) to initiate further override action.
   NOTE: If this procedure fails to remove the blockage, the anti-trap feature will be lost and must be reset after the blockage is cleared or rectified.

   Window motor thermal overload protection  - If the windows are repeatedly opened and closed, a protection system will de-activate window operation for a short period to avoid overheating of the window electric motors.