Removal And Installation: Removal
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the cover and disconnect the battery ground cable.
For additional information, refer to: Battery, Mounting And Cables -- XK/X150 (Specifications).
- Remove the instrument panel.
For additional information, refer to: Instrument Panel (Removal and Installation).
- Remove the windshield wiper arms.
For additional information, refer to: Wiper Pivot Arm (Removal and Installation).
Remove the throttle pedal assembly.
- Remove the 3 Torx screws.
- Disconnect the electrical connector.
Release the brake switch.
- Rotate clockwise approximately 30 degrees.
Release the brake booster.
- Remove the brake pedal clevis pin.
- Remove the 4 nuts.
Remove the nuts from the brake pedal bracket.
- Remove the 5 nuts.
-
NOTE: Working from the engine bay.
Remove the air intake cover.
- Remove the 4 clips.
Remove the brake master cylinder cover.
- Remove the 3 clips.
Remove the plenum chamber panel.
- Release the retaining clip.
- Release the 3 clips.
- Disconnect the washer jet hose.
Remove the brake pedal bracket.
- Remove sealant for access to the bulkhead screw heads.
- Remove the 4 screws.
- Release the electrical harness clip.