LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Hydraulic Brake Actuation -- XK/X150) >> Hydraulic Brake Actuation >> Brake Pedal And Bracket (G545787) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake pedal bracket.
    • Align to the studs and lightly tighten the nuts.
    • Install and tighten the bulkhead screws.
    • Apply sealant to the bulkhead screw heads.
    • Secure the electrical harness with the clip.
  2. Tighten the brake pedal bracket nuts to 25 Nm (18 lb.ft).
  3. Install the plenum chamber panel.
    • Connect the washer jet hose.
    • Carefully secure the clips.
  4. Install the brake master cylinder cover.
    • Carefully secure the clips.
  5. Install the air intake cover.
    • Carefully secure the clips.
  6. Secure the brake booster.
    • Tighten the nuts to 25 Nm (18 lb.ft).
    • Install the brake pedal clevis pin.
  7. Install the brake switch.
  8. Install the throttle pedal assembly.
    • Connect the electrical connector.
    • Install the Torx screws.
  9. Install the windshield wiper arms.

    For additional information, refer to: Wiper Pivot Arm (Removal and Installation).

  10. Install the instrument panel.

    For additional information, refer to: Instrument Panel (Removal and Installation).

  11. Connect the battery ground cable and install the cover.

For additional information, refer to: Battery, Mounting And Cables -- XK/X150 (Specifications)

scientia non olet · About LEMON Manuals