Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.

Remove the brake fluid reservoir.
For additional information, refer to: BRAKE FLUID RESERVOIR (Removal And Installation).
Release and disconnect the electrical connector.
- Fully loosen the bolt.
NOTE: Some fluid spillage is inevitable during this operation.

Disconnect the brake master cylinder lines.
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.

Remove the brake master cylinder.
- Remove the 2 nuts.

Remove and discard the O-ring seal.