LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Power Brake Actuation -- XK/X150) >> Power Brake Actuation >> Brake Booster - LHD RWD (G546437) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake master cylinder.

    For additional information, Refer To: Brake Master Cylinder - LHD (Removal and Installation).

  2. CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
    G11512079

    Remove the driver's side footwell trim panel.

    • Carefully release the 3 clips.
  3. G11512080

    Release the brake switch.

    • Rotate clockwise approximately 30 degrees.
  4. G11512081

    Release the vacuum pipe.

  5. G11512082

    Remove the brake booster.

    • Remove the brake pedal clevis pin.
    • Remove the 4 nuts.
  6. Remove and discard the gasket.
scientia non olet · About LEMON Manuals