LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Power Brake Actuation -- XK/X150) >> Power Brake Actuation >> Brake Booster - LHD RWD (G546437) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new gaskets.
  2. Install the brake booster.
    • Tighten the nuts to 25 Nm (18 lb.ft).
    • Install the brake pedal clevis pin.
  3. Connect the vacuum hose.
  4. Install the brake switch.
  5. Install the driver's side footwell trim panel.
    • Carefully align and secure the clips.
  6. Install the brake master cylinder.

    For additional information, Refer To: Brake Master Cylinder - LHD (Removal and Installation).

scientia non olet · About LEMON Manuals