LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Battery, Mounting & Cables -- XK/X150) >> Battery, Mounting And Cables >> Battery (Removal And Installation) (G1082108) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Make sure the battery monitoring system (BMS) electrical connector is connected to the module, before installing the BMS on to the battery terminal.

    To install, reverse the removal procedure.

  2. NOTE: This step is only necessary when installing a new battery.

    Using Jaguar approved diagnostic equipment, reset the battery monitoring system (BMS).

  3. Door Window Motor Initialization.
  4. Enter the audio unit preset radio frequencies.
  5. Reset the clock to the correct time.
  6. Start the engine and allow to idle until the engine reaches normal operating temperature.
  7. Switch the engine off.
scientia non olet · About LEMON Manuals