LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Pedestrian Protection System -- XK/X150) >> Pedestrian Protection System >> Left Pedestrian Protection Hood Actuator >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pedestrian protection actuator.
    • Tighten the new Torx bolts to 8 Nm (6 lb.ft).
  2. Install the pedestrian protection actuator and bracket.
    • Connect the electrical connector.
  3. Secure the pedestrian protection actuator bracket.
    • Attach the wiring harness clips.
    • Tighten the bolts to 8 Nm (6 lb.ft).
  4. Position and install the power distribution box.
    • Tighten the Torx bolts to 8 Nm (6 lb.ft).
  5. Install the pollen filter.

    For additional information, refer to: Pollen Filter

scientia non olet · About LEMON Manuals