LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Handles, Locks, Latches & Entry Systems -- XK/X150) >> Handles, Locks, Latches And Entry Systems >> Hood Latch >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pedestrian protection latch actuator.
    • Connect the electrical connector.
    • Tighten the new Torx bolts to 9 Nm (7 lb.ft).
  2. Install the hood latch.
    • Attach the latch cable.
  3. Install the hood switch.
    • Secure in the clips.
  4. Secure the hood latch.
    • Connect the electrical connectors.
    • Tighten the bolts to 10 Nm (7 lb.ft).
  5. Install the pedestrian protection actuator and bracket.

    For additional information, refer to: Pedestrian Protection Hood Actuator LHPedestrian Protection Hood Actuator RH

scientia non olet · About LEMON Manuals