Coolant Pump - V8 S/C 5.0L Petrol: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Refer to Battery Disconnect and Connect information.
- Raise and support the vehicle.
- Refer to Engine Cover - 5.0L information.
- Refer to Cooling System Draining and Vacuum Filling information.
- Refer to Supercharger Belt information.
- See figure
- See figure
- Torque: 40 Nm
- See figure
- Torque: 12 Nm
- See figure
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
CAUTION:
Make sure that the accessory drive belt is correctly located on each pulley.
CAUTION:
Clean and inspect the accessory drive belt pulleys for damage.
WARNING:
Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.
CAUTION:
Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
CAUTION:
Note the fitted position of the component prior to removal.