LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake Actuation >> Hydraulic Brake Actuation >> Removal And Installation >> Brake Pedal And Bracket >> Removal

Brake Pedal And Bracket: Removal

  1. Remove the cover and disconnect the battery ground cable. Refer to Specifications information..
  2. Remove the instrument panel. Refer to Instrument Panel information..
  3. Remove the windshield wiper arms. Refer to Wiper Pivot Arm information..
  4. Remove the throttle pedal assembly.
    • Remove the 3 Torx screws.
    • Disconnect the electrical connector.
    GJ0009598
  5. Release the brake switch.
    • Rotate clockwise approximately 30 degrees.
    GJ0009599
  6. Release the brake booster.
    • Remove the brake pedal clevis pin.
    • Remove the 4 nuts.
    GJ0009600
  7. Remove the nuts from the brake pedal bracket.
    • Remove the 5 nuts.
    GJ0009601
    8. NOTE: Working from the engine bay.
  8. Remove the air intake cover.
    • Remove the 4 clips.
    GJ0008902
  9. Remove the brake master cylinder cover.
    • Remove the 3 clips.
    GJ0008901
  10. Remove the plenum chamber panel.
    • Release the retaining clip.
    • Release the 3 clips.
    • Disconnect the washer jet hose.
    GJ0008903
  11. Remove the brake pedal bracket.
    • Remove sealant for access to the bulkhead screw heads.
    • Remove the 4 screws.
    • Release the electrical harness clip.
    GJ0009602
scientia non olet · About LEMON Manuals