Overhead Console Switch Molding: Removal
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Remove the overhead console. See Overhead Console .
- Remove the front intrusion sensor.
- Remove the garage door opener module.
- Remove the printed circuit board (PCB) cover.
- Using a 5mm drill bit, carefully drill out and remove the 4 plastic fixing heads.
- Remove the PCB.
- Remove the two switch moldings.
- Remove the foam pad.
- Carefully remove sunroof rocker switch for reuse in the new rear switch molding.
NOTE:
Where installed.
NOTE:
Where installed.
CAUTION:
Make sure that only the head of the fixing is removed. Do not drill any deeper than necessary. Failure to follow this instruction may result in damage to the component.