LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel & Console >> Instrument Panel And Console >> Removal And Installation >> Overhead Console Switch Molding >> Installation

Overhead Console Switch Molding: Installation

  1. Select the correct switch molding for the vehicle from the parts kit.
  2. Remove any unnecessary switch buttons from the rear molding using a suitable sharp knife. Take care not to remove any required switches.
  3. Install the sunroof rocker switch.
  4. Install the front switch molding.
  5. Install the foam pad.
  6. Install the rear switch molding.
  7. Install the PCB.
  8. Install the cover.
    • Install the 4 Torx screws
    • Tighten to 1.5 Nm.
    GJ0025744
  9. Install the garage door opener module.
  10. Install the front intrusion sensor.
  11. Install the overhead console. See Overhead Console .
scientia non olet · About LEMON Manuals