Instrument Panel Lower Trim Panel: Removal
- Remove the instrument panel end trim panel.
- Open the front door for access.
- Carefully release the 3 clips.
- Remove the instrument panel driver's side reinforcement trim panel.
- Carefully release the 4 clips.
- Carefully release and remove the rheostat switch assembly.
- Disconnect the electrical connector.
- Remove the driver's side footwell trim panel.
- Carefully release the 3 clips.
- Release the MOST diagnostic port.
- Carefully release the clip.
- Remove the instrument panel, lower trim panel.
- Remove the 3 Torx bolts.
- Remove the 2 Torx screws.
- Release the 2 clips.
- Release the vehicle diagnostic port.
CAUTION:
Care must be taken to avoid damage to the mating surfaces.
CAUTION:
Removal of the clips is a delicate procedure, damage will occur if any force is used.