LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XFR >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Fuel Tank & Lines - GTDI 2.0L Petrol -- XF/X250) >> Fuel Tank And Lines - GTDI 2.0L Petrol >> Diagnosis And Testing >> Fuel Tank And Lines >> Pinpoint Tests >> Pinpoint Test H: Fuel Pump Driver Module Tests

Pinpoint Test H: Fuel Pump Driver Module Tests

WARNING: This page is about a different car, the 2015 Jaguar XF, 2014 Jaguar XF, and 2013 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
  1. H1: FUEL PUMP DRIVER MODULE TEST 1 
    1. Set the ignition to off.
    2. Using the manufacturer approved diagnostic system, check datalogger signal - Fuel Pump Duty Cycle (0x0307)
      NOTE: This test is performed whilst the fuel pump is priming the fuel system.
    3. Set the ignition to on and check the datalogger signal.

    Is the datalogger signal less than or equal to 50%?

    • Yes  : Refer to the applicable SYSTEM WIRING DIAGRAM(S) and check the fuel pump driver module circuits for short circuit to ground, short circuit to power, open circuit, high resistance. Repair as necessary and retest.
    • No  : Using the manufacturer approved diagnostic system, check the restrains control module for crash event related DTCs and refer to the relevant DTC index.
scientia non olet · About LEMON Manuals